Page | 42
4.3.15 Digital Output Test
Pins 1 to 8 on the connector J6 can output the digital voltages 0V and 3.3V,
the default output is 3.3v.
1. Device introduction:
[root@OMAP3EVM /]# cd /sys/class/misc/digital/
[root@OMAP3EVM digital]# ls
dev out2 out4 out6 out8 power uevent
out1 out3 out5 out7 outall subsystem
As above, out1 corresponds to the pin1; the outall corresponds to pins 1 to
8.
2. Set only one pin voltage (pin3):
[root@OMAP3EVM digital]# echo 1 > out3
[root@OMAP3EVM digital]# cat out3
1
3. Set all pins voltage:
[root@OMAP3EVM digital]# echo aa > outall
[root@OMAP3EVM digital]# cat outall
aa
4.4 Linux Image Update
The SOC8200 supports MMC/SD boot or NAND boot; different start-up
modes have different methods for updating the image. Here we will
introduce the image update process under different start-up modes.
4.4.1 Update the image on an SD card
Preparation
The first step is to format the SD card. The HP USB Disk Storage Format Tool
is recommended:
The software can be downloaded from:
http://www.embest-tech.com/resource/download/HP-USB-Disk-S
torage-Format-Tool.rar
Comments to this Manuals