Embest SBC8140 User Manual download pdf (Page 78)

Page | 72

11648 bytes read

HW ECC selected

NAND write: device 0 offset 0x0, size 0x2d80

12288 bytes written: OK

reading flash-uboot.bin

231872 bytes read

SW ECC selected

NAND write: device 0 offset 0x80000, size 0x389c0

233472 bytes written: OK

reading uImage

2548700 bytes read

SW ECC selected

NAND write: device 0 offset 0x280000, size 0x26e3dc

2549760 bytes written: OK

reading ubi.img

12320768 bytes read

SW ECC selected

NAND write: device 0 offset 0x680000, size 0xbc0000

12320768 bytes written: OK

When the LEDs on the kit start to blink, the update is completed; please

remove the SD card and reboot the system;

3.7 Display Mode Configuration

The system supports multiple display modes. Users can select an

appropriate mode by configuring boot parameters. The following contents

show how to configure for both 4.3” and 7” LCDs, VGA mode and LVDS

mode.

You need to enter u-boot mode to complete these configurations. Please

reboot the kit and press any key on your PC’s keyboard when the system

prompts you with a countdown in seconds as shown below;

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 143 144

No comments

Embest SBC8140 User Manual Page 78